I have been playing with Multicast Resource Manager, easy enough to
configure.. I can see control messages going back and forth to both
sender and recievers... If I run a debug ip mpacket on the sender and
recievers I see the packets being sent and recieved without issue...
However I get a constant stream of 100% loss status report messages.
My config is identicle to that on guide docs, just sender/receiver
ip's changed as needed.
I can't figure it out... All documentation just implies this is
correct config.
This is implemented on real hardware on a remote lab, so not your
normal dynamips errors. If configure icmp join on either sender or
recievers I can ping back and forth...
Anyone got any thourghts?
R1
Int s0/0/0
Ip mrm test-sender-recievers
!
R2
int s0/0/0
Ip mrm test-sender-recievers
!
R3
Ip mrm manager MRM
Manager s0/0/0.336 group 239.1.1.1
Sender 1
Reciever 1 sende 1
!
Access-list 1 permit host 110.1.0.3
Access-list 1 permit host 110.1.0.4
!
mrm MRM start
Sent from my iPhone
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
