While configuring the rate-limit command I noticed that the numbers I put in
were being changed to something else. For example, when I put in 1500000 it
modifies it to 1496000. Can anyone tell me why this happens?
inter fa0/0
rate-limit output 1500000 64000 64000 conform transmit exceed drop
interface FastEthernet0/0
ip address 150.100.12.1 255.255.255.0
rate-limit output 1496000 64000 64000 conform-action transmit exceed-action drop
priority-group 1
R1#show int fa0/0 rate-limit
FastEthernet0/0 Link to R2
Output
matches: all traffic
params: 1496000 bps, 64000 limit, 64000 extended limit
conformed 5 packets, 428 bytes; action: transmit
exceeded 0 packets, 0 bytes; action: drop
last packet: 1276ms ago, current burst: 0 bytes
last cleared 00:00:39 ago, conformed 0 bps, exceeded 0 bps
Thank you,
Steve
UHS Confidentiality Notice: This e-mail message, including any attachments, is
for the sole use of the intended recipient (s) and may contain confidential and
privileged information. Any unauthorized review, use, disclosure or
distribution of this information is prohibited. If this was sent to you in
error, please notify the sender by reply e-mail and destroy all copies of the
original message.
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
