Also a good idea Sent from G2
marc abel <[email protected]> wrote: I think he needs to disable it on the other end. On Sun, Sep 4, 2011 at 5:12 PM, Di Bias, Steve <[email protected]> wrote: > Maybe it was learned before you disabled inverse arp? Try reloading your > router and check again > > Sent from G2 > > Sanjay Singh <[email protected]> wrote: > > > Hello, > > I was doing lab on FR on GNS3 and observed below. I m bit confused, how the > map is being learnt dynamically if i have disabled inverse-arp. > > I have created DLCI mapping on FR Switch but if i have disabled inverse arp, > it should not learn.. pls guide me .. if i m on wrong track. > > R3#sh frame-relay map > Serial1/0 (up): ip 10.0.0.1 dlci 301(0x12D,0x48D0), static, > CISCO, status defined, active > Serial1/0 (up): ip 10.0.0.2 dlci 302(0x12E,0x48E0), dynamic, >>>>>>>>>>>>>>>>> Dynamic map > broadcast,, status defined, active > R3#conf t > Enter configuration commands, one per line. End with CNTL/Z. > R3(config)# > R3(config)# > R3(config)#do sh run int s1/0 > Building configuration... > Current configuration : 221 bytes > ! > interface Serial1/0 > ip address 10.0.0.3 255.0.0.0 > encapsulation frame-relay > ip ospf priority 0 > serial restart-delay 0 > no dce-terminal-timing-enable > frame-relay map ip 10.0.0.1 301 > no frame-relay inverse-arp >>>>>>>>>>>>>>>>>>>>>> disabled inverse-arp > end > > > Regards, > *Sanjay Singh* > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > > UHS Confidentiality Notice: This e-mail message, including any attachments, > is for the sole use of the intended recipient (s) and may contain > confidential and privileged information. Any unauthorized review, use, > disclosure or distribution of this information is prohibited. If this was > sent to you in error, please notify the sender by reply e-mail and destroy > all copies of the original message. > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > UHS Confidentiality Notice: This e-mail message, including any attachments, is for the sole use of the intended recipient (s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution of this information is prohibited. If this was sent to you in error, please notify the sender by reply e-mail and destroy all copies of the original message. _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
