Where do we submit errors/typos found in the works ? I am keeping track of the ones I find, but I not sure who to forward them to.
Thanks, Max -----Original Message----- From: Di Bias, Steve [mailto:[email protected]] Sent: Tuesday, September 27, 2011 3:45 PM To: Max Kamali; [email protected] Subject: RE: [OSL | CCIE_RS] Vol1 Task 23.4 GTS You're right on the money Max! The way I interpreted this is that you need to configure excess as a "0" >From what I can tell IPexpert didn't configure the Be value and just hit enter. of course IOS is very polite and will automagically configure it for us which is why you see those numbers in the DSG In my opinion anything other than a "0" is a violation of the task You get the points in my eyes Thank you, Steve Di Bias Network Engineer - Information Systems Valley Health System - Las Vegas Office - 702- 369-7594 Cell - 702-241-1801 [email protected] -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Max Kamali Sent: Tuesday, September 27, 2011 1:08 PM To: [email protected] Subject: [OSL | CCIE_RS] Vol1 Task 23.4 GTS Hi, Task 23.4 is asking for GTS configs on the frame link se0/0/0.24 of R4, Telnet/icmp 15% of BW ftp 50% BW after shaping all other traffic gets remaining 35% of BW use WFQ no excess bursts should be allowed The DSG is showing the output of a "sh traffic-shape se0/0/0.24" on R4 with excess burst values. If the requirements ask for no excess burst then wouldn't the correct answer for this part of the solution be the following traffic-shape group 101 9600 1200 0 traffic-shape group 102 32000 4000 0 traffic-shape group 103 22400 2800 0 Instead of the dsg configs below? traffic-shape group 101 9600 traffic-shape group 102 32000 traffic-shape group 103 22400 Thank you, Max _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com UHS Confidentiality Notice: This e-mail message, including any attachments, is for the sole use of the intended recipient (s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution of this information is prohibited. If this was sent to you in error, please notify the sender by reply e-mail and destroy all copies of the original message. _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
