Copied the config back to before the first crash and it crashed
again a few minutes later, back to initial config dialog.
From: Johan Bornman [mailto:[email protected]]
Sent: 27 June 2009 07:49
To: '[email protected]'
Subject: Router crashed
Hi,
Was doing Lab2A task 2.16. The router and I must have been in the
same state of mind with this task. The router crashed. Just wanted
to make you (IPExpert) aware.
The router then rebooted and started with:
Would you like to enter the initial configuration dialog? [yes/no]:
% Please answer 'yes' or 'no'.
What will happen if this happens in the exam? Will I get time credit
and the procotor has to repair (Load initial config, etc)
See crash info below.
Rgds
Johan
Crash info:
%ALIGN-1-FATAL: Illegal access to a low address 06:44:48 UTC Sat Jun
27 2009
addr=0x1, pc=0x642246F0 , ra=0x63C53F7C , sp=0x68E92AE8
%ALIGN-1-FATAL: Illegal access to a low address 06:44:48 UTC Sat Jun
27 2009
addr=0x1, pc=0x642246F0 , ra=0x63C53F7C , sp=0x68E92AE8
06:44:48 UTC Sat Jun 27 2009: TLB (store) exception, CPU signal 10,
PC = 0x642246F0
--------------------------------------------------------------------
Possible software fault. Upon reccurence, please collect
crashinfo, "show tech" and contact Cisco Technical Support.
--------------------------------------------------------------------
-Traceback= 0x642246F0 0x63C53F7C 0x63DCBF9C 0x6201AA04 0x6201ACF0
0x62006B60 0x620012B8 0x61FFA668 0x62006A3C 0x62006BC8 0x62019744
0x62014FE0 0x620154A8
$0 : 00000000, AT : 67210000, v0 : 00000001, v1 : 00000001
a0 : 00000001, a1 : 00000000, a2 : 000000B0, a3 : 00000000
t0 : 0000002C, t1 : 00000000, t2 : 00000001, t3 : 676D0000
t4 : 00000000, t5 : 00000000, t6 : 00000000, t7 : 00000002
s0 : 00000001, s1 : 7112CC24, s2 : 00000006, s3 : 68E92B48
s4 : 00000000, s5 : 00000001, s6 : 66E10000, s7 : 660A0000
t8 : 675C7CF0, t9 : 67180000, k0 : 6934AD9C, k1 : 633D8AE0
gp : 6721E3E0, sp : 68E92AE8, s8 : 00000002, ra : 63C53F7C
EPC : 642246F0, ErrorEPC : BFC05CFC, SREG : 3400FF03
MDLO : 0012BBE0, MDHI : 00000000, BadVaddr : 00000001
DATA_START : 0x64265E80
Cause 0000000C (Code 0x3): TLB (store) exception
Writing crashinfo to flash:crashinfo_20090627-064448
06:44:48 UTC Sat Jun 27 2009: TLB (store) exception, CPU signal 10,
PC = 0x642246F0
--------------------------------------------------------------------
Possible software fault. Upon reccurence, please collect
crashinfo, "show tech" and contact Cisco Technical Support.
--------------------------------------------------------------------
-Traceback= 0x642246F0 0x63C53F7C 0x63DCBF9C 0x6201AA04 0x6201ACF0
0x62006B60 0x620012B8 0x61FFA668 0x62006A3C 0x62006BC8 0x62019744
0x62014FE0 0x620154A8
$0 : 00000000, AT : 67210000, v0 : 00000001, v1 : 00000001
a0 : 00000001, a1 : 00000000, a2 : 000000B0, a3 : 00000000
t0 : 0000002C, t1 : 00000000, t2 : 00000001, t3 : 676D0000
t4 : 00000000, t5 : 00000000, t6 : 00000000, t7 : 00000002
s0 : 00000001, s1 : 7112CC24, s2 : 00000006, s3 : 68E92B48
s4 : 00000000, s5 : 00000001, s6 : 66E10000, s7 : 660A0000
t8 : 675C7CF0, t9 : 67180000, k0 : 6934AD9C, k1 : 633D8AE0
gp : 6721E3E0, sp : 68E92AE8, s8 : 00000002, ra : 63C53F7C
EPC : 642246F0, ErrorEPC : BFC05CFC, SREG : 3400FF03
MDLO : 0012BBE0, MDHI : 00000000, BadVaddr : 00000001
DATA_START : 0x64265E80
Cause 0000000C (Code 0x3): TLB (store) exception
-Traceback= 0x642246F0 0x63C53F7C 0x63DCBF9C 0x6201AA04 0x6201ACF0
0x62006B60 0x620012B8 0x61FFA668 0x62006A3C 0x62006BC8 0x62019744
0x62014FE0 0x620154A8
=== Flushing messages (06:44:49 UTC Sat Jun 27 2009) ===
Queued messages:
L2 ECC Counter = 0000000000000000
Memory and IO Err Counter = 0000000000000000
Bus Watcher Counters
cor_l2cache_data_ecc_count = 0
bad_l2cache_data_ecc_count = 0
cor_l2cache_tag_ecc_count = 0
bad_l2cache_tag_ecc_count = 0
cor_memory_data_ecc_count = 0
bad_memory_data_ecc_count = 0
bus_errors = 0
CPU temp is 48
Temp1 temp is 24
Temp2 temp is 22
Internal voltage is 3316
Remote voltage1 is 5153
Remote voltage2 is 2525
Remote voltage3 is 1203
bsp; Remote voltage1 is 5153
Remote voltage2 is 2525
Remote voltage3 is 1203
