Spot on that was my next response :-) 2009/9/8 Dave Craddock <[email protected]>
> Sorry hit the send button before I finished > > > > When you do the no ip routing it doesn’t stop the router being a layer3 > device it just stops it routing traffic to unknown networks if you are on > interface 1 you can still ping an address on interface 2 but you can’t route > traffic from a host on network 1 to a host on network 2. > > > > To make the router into a bridge you need to use bridge groups on the > interfaces that you want to bridge together and then tell the router what > you want to bridge i.e bridge ip route ipx etc > > > > Dave > > > > *From:* [email protected] [mailto: > [email protected]] *On Behalf Of *Kingsley Charles > *Sent:* 08 September 2009 11:40 > *To:* [email protected] > *Subject:* Re: [OSL | CCIE_Security] ASA support of trunking > > > > My topology > > > > > > (host routerA) 1841 ---------- L2 1841 L2 -------------- G 0/1(inside) ASA > (outside) G 0/0 ------------outside world ---------- telnet server host > (router) > (switch) > > On Tue, Sep 8, 2009 at 3:51 PM, Kingsley Charles < > [email protected]> wrote: > > Hi > > > > I have a host routerA connected to a switch port of 1841 (access vlan 6) > and other port (access vlan 6) is connected to the ASA (inside g0/1). The > ASA is connected to the outside world > > through g0/0 (outside). > > > > I have configured PAT on the ASA. > > > > I have disabled "ip routing" on the ASA, such that it has switching > functionality alone. > > > > Now I am trying to make telnet connection from the host routerA to a > host in the outside world but I get the following error message on the > router. > > > > % Connection refused by remote host > > > > > > I am able to ping the inside interface of the ASA from the host routerA. > > > > > > The PAT is not happening and the ASA is refusing the connection. > > > > If I remove the switch (1841) and connect the host routerA (from L3 > interface) directly to ASA inside interface, the PAT is happening and I am > to telnet. > > > > > > I am observing that when I use L2 ports, the connectivity doesn't go > through the ASA. > > > > I even tried converting the ASA inside interfaace to a trunk and making the > switch port into a trunk but still I see the same problem. > > > > For both cases using inside interface in access mode and trunk mode, ASA > refuses the connection. > > > > What could be the problem? > > > > > > > > > > With regards > > Kings > > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
