Hi Mohammed, Thanks for point out mistake. It works.
Actually I was under impression that Hub tunnel interface had those commands as I was doing another tests in DMVPN setup and those commands were configured on tunnel interface. I didn't notice that I have removed those commands. Thanks once again. Regards, D.M.Gore 2009/9/26 Mohammed Gazzaz <[email protected]> > Please Add the following commands under the tunnel interface in the hub > > ! Turns off split horizon on the mGRE tunnel interface; otherwise, EIGRP will > not > advertise routes that are learned via the mGRE interface back out that > interface. > > no ip split-horizon eigrp 1 > > ! Enables dynamic, direct spoke-to-spoke tunnels when using EIGRP. > > no ip next-hop-self eigrp 1 > > regards, > Mohammed Gazzaz > > ------------------------------ > Date: Sat, 26 Sep 2009 16:53:12 +0530 > From: [email protected] > To: [email protected] > Subject: [OSL | CCIE_Security] DMVPN: Hub behind NAT device > > > Hi, > > I am configuring DMVPN setup with HUB device behind NAT device (ASA). > Static NAT is used for HUB physical interface. Two spokes are able to > establish VPN session with HUB successfully. But spokes are not getting peer > spoke subnet/ip address information over EIGRP DMVPN routing protocol. They > are able to get HUB subnet information over EIGRP. > > I am not able to figure out the reason behind this. Kindly help me to > troubleshoot this. > > I have attached HUB, spokes & ASA configurations, output of all device and > diagram for your reference. > > Regards, > D.M.Gore > > > > ------------------------------ > Express yourself instantly with MSN Messenger! MSN > Messenger<http://clk.atdmt.com/AVE/go/onm00200471ave/direct/01/> >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
