Hi TacACK These commands are used to accept the "TCP resets" ingress traffic from the monitoring interface.
*The following commands tags the TCP reset with dot1q and * *vlan ID of 6* ** *monitor session 2 destination interface gigabitethernet0/2 ** encap dot1q ** ingress dot1q vlan 6 * The following commands are both same. Configure them and check in the "sh run", they will both will have the same syntax. With this, TCP resets are sent untagged monitor session 2 destination interface gigabitethernet0/2 encap dot1q ingress vlan 6 monitor session 2 destination interface gigabitethernet0/2 ingress untagged vlan 6 With regards Kings On Fri, Jun 18, 2010 at 8:37 PM, Vybhav Ramachandran <[email protected]>wrote: > Hello All, > > Can someone please explain what the difference between these commands are > > *monitor session 2 destination interface gigabitethernet0/2 encap dot1q > ingress vlan 6 * > > * > > monitor session 2 destination interface gigabitethernet0/2 > > encap dot1q > > ingress dot1q vlan 6 > > monitor session 2 destination interface gigabitethernet0/2 ingress untagged > vlan 6 > > Thanks in advance, > > Cheers, > > TacACK > > * > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
