Thank you. On Mon, Apr 18, 2011 at 6:39 AM, Kingsley Charles < [email protected]> wrote:
> ntaive vlans are by default are sent untagged in trunk ports. "vlan dot1q > tag native" tags native vlan. > > With regards > Kings > > > On Mon, Apr 18, 2011 at 5:21 PM, Jim Terry <[email protected]> wrote: > >> Hi all, >> >> I am not familiar with this command: vlan dot1q tag native and the 3560 >> config Guide does not explain it in words that I can comprehend. What does >> it do? >> >> JT >> >> >> >> >> On Sat, Apr 16, 2011 at 11:01 AM, Kingsley Charles < >> [email protected]> wrote: >> >>> Hi all >>> >>> I tried to configure inline vlan pair on a sensor pairing vlan 1 and 23. >>> I enabled 2004 and 2000 signatures.Traffic from 23 was coming in but not >>> from vlan 1 i.e., it was unidirectional. Since vlan 1 is the native vlan, it >>> should have been sent untagged and hence the sensor didn't swap it. Hence I >>> tried configuring* vlan dot1q tag native *and changing the native vlan >>> to some other vlan other than 1, still I faced the same issue. >>> >>> What could be the problem? >>> >>> >>> With regards >>> Kings >>> >>> _______________________________________________ >>> For more information regarding industry leading CCIE Lab training, please >>> visit www.ipexpert.com >>> >>> >> >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com >> >> >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and Looking for a Job check out www.PlatinumPlacement.co
