IMO, yes :) 2011/5/16 Kok Yong CHEONG <[email protected]>
> hi guys, that means it is "normal" ? > > thanks > KY > > > On Mon, May 16, 2011 at 12:08 AM, Piotr Matusiak <[email protected]> wrote: > >> Yes, there is an issue. Same with FWSM, I think it was never designed to >> be working :) >> >> Regards, >> Piotr >> >> >> 2011/5/15 Kok Yong CHEONG <[email protected]> >> >>> hi, >>> >>> just observed 1 thing. when configure ASA in multiple context mode and >>> with failover configuration, when you configure your failover interface ip >>> XXX 10.1.1.1 255.255.255.0 standby 10.1.1.2. >>> >>> i can't ping 10.1.1.1 but i can ping 10.1.1.2 from the primary ASA, when >>> i go to secondary ASA, i can ping 10.1.1.1 but not 10.1.1.2, i remember if >>> i'm NOT in multicontext mode, i can ping both IP address. just want to >>> confirm and curious on this behavior ? why is that so ? >>> >>> any input is greatly appreciated. >>> >>> thanks in advance >>> >>> Regards >>> KY >>> >>> >>> _______________________________________________ >>> For more information regarding industry leading CCIE Lab training, please >>> visit www.ipexpert.com >>> >>> Are you a CCNP or CCIE and looking for a job? Check out >>> www.PlatinumPlacement.com >>> >> >> >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
