Which command is that? I do not have it SW2(config-if)#ip verify source ? port-security port security <cr>
On Sun, May 29, 2011 at 10:17 AM, Jim Terry <[email protected]> wrote: > Hi all, > > Here is my question but in more detail: > > What does this do: > > Switch(config)# ip device tracking > Switch(config)# *interface gigabitethernet 0/3 > *Switch(config-if)# switchport mode access > Switch(config-if)# switchport access vlan 10 > Switch(config-if)# ip device tracking maximum 5 > Switch(config-if)# ip verify source tracking > Switch(config-if)# end > I dont understand what device tracking does. > > Thanks, > > JT > > > > On Sat, May 28, 2011 at 10:27 AM, Kingsley Charles < > [email protected]> wrote: > >> Can you elaborate your question. >> >> With regards >> Kings >> >> On Sat, May 28, 2011 at 7:29 PM, Jim Terry <[email protected]> wrote: >> >>> Hi all, >>> >>> I am looking at the 3560 config guide and on the section for IPSG it >>> talks about a static host(the section that has IP device tracking). I know >>> it is different than adding a binding to a non dhcp host but I still dont >>> understand the concept. >>> >>> Can anyone enlighten me? >>> >>> JT >>> >>> >>> >>> _______________________________________________ >>> For more information regarding industry leading CCIE Lab training, please >>> visit www.ipexpert.com >>> >>> Are you a CCNP or CCIE and looking for a job? Check out >>> www.PlatinumPlacement.com <http://www.platinumplacement.com/> >>> >> >> > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > -- Bruno Fagioli (by Jaunty Jackalope) Cisco Security Professional
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
