When I needed to test the span, vlanpairs, etc, I did it on real catalyst. So I suggest to just skip this part of the training until such time as you will have access to real hardware.
On Tue, Nov 8, 2011 at 7:05 PM, HA Ali <[email protected]> wrote: > I am doing the IPS part from INE workbook on GNS3 . I am stuck with a > problem . > > > It says to do SPAN using VLAN as source and there should be 2 SPAN > sessions as there are 2 VLAn in this toplogy . Now the problem is that this > NM16ESW module doesnt supports SPAN using VLAN as source , it gives me > following error > > SW(config)#monitor session 1 source vlan 12 > SPAN Source Vlan is not supported in this platform > > Also it supports only 1 span session at a time . > > Is there a workaround in GNS3 to make things work properly ? What will you > suggest in this solution . > > awaitng reply > > ------------------------------ > Date: Thu, 3 Nov 2011 17:46:59 +0600 > Subject: Re: [OSL | CCIE_Security] And i'm pass too > From: [email protected] > To: [email protected] > CC: [email protected] > > After 5min initialization it is about 15-20% > > On Thu, Nov 3, 2011 at 5:41 PM, HA Ali <[email protected]> wrote: > > I have pentium D 935 . I tried running it but the GUI was very slow and > it gave me error that it is stuck something like that with a process . So > Today I will give it a try again and I will try to keep it idle for 5 > minutes and then try . The CPU was 100% when I did it . What was the CPU > when you used to run IPS . > > > > ------------------------------ > Date: Thu, 3 Nov 2011 17:19:28 +0600 > > Subject: Re: [OSL | CCIE_Security] And i'm pass too > From: [email protected] > To: [email protected] > CC: [email protected] > > > Hi, > > Yes, IPS 6.0 worked fine, it need less than 5 minute for full start, > all you need is follow EXACTLY all steps in that guide > http://www.brainbump.net/2011/01/how-to-emulate-cisco-ips. > I have HP 6550b, with 4gb ram and i5 cpu, but this is not mandatory, 3gb & > core 2 duo also nice. > > Thanks and good luck! > > On Thu, Nov 3, 2011 at 5:09 PM, HA Ali <[email protected]> wrote: > > > THanks , > I want to know about IPS Emulation . Were you able to do it sucessfully on > PC . I tried it and it hangs and it takes too much time . People told me > that its useless to put effort on IPS Emulation . > > > Did it worked for you if yes please let me know your PC hardware config . > > Thanks > > Congratz for the CCIE # . I hope I will also have it in coming months . > > > ------------------------------ > Date: Thu, 3 Nov 2011 16:53:33 +0600 > From: [email protected] > To: [email protected] > Subject: Re: [OSL | CCIE_Security] And i'm pass too > > > Oh sorry guys, i forget to post report, so here it is: > http://www.2bitornot2bit.net/2011/09/24/ccie-security-passed/ > > On Sun, Sep 25, 2011 at 1:06 AM, Andrey <[email protected]> wrote: > > Thank you all, guys! > For those of you who have asked for more details, i will try to write > report in blog very soon and post it here. > Best regards, > Andrey > > > > > -- > Best regards, > Andrey > > > _______________________________________________ For more information > regarding industry leading CCIE Lab training, please visit > www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > > > > -- > Best regards, > Andrey > > > > > -- > Best regards, > Andrey > > -- Best regards, Andrey
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
