HI Kings, This might help.
http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a00806cd87b.shtml I had a customer once (call centre/admin type environment), who on their DR site, had a simple hub & spoke switching environment with HP Procurves in the core and some small Ciscos for access. The Ciscos (cant recall exactly what they were, but IIRC the vintage would have assumed 3500XLs, 3550s at best) seemed to like putting the trunk ports back to the HPs into err-disable for some silly reason. Really good for their "DR site" and the client only discovered that their DR didnt "R" from their "D" until they tried to pull the plug on their main site to see what would happen :/ PS I know you mentioned "not using err-disable recovery" and that is exactly what I just suggested, but what else would you want? It _is_ the automatic way of recovery, and does not require the manual intervention of shut/no shut or a reload? Cheers, Matt CCIE #22386 CCSI #31207 On 17 March 2012 19:20, Kingsley Charles <[email protected]> wrote: > Hi all > > To enable error disable ports other than manually performing shut/no shut or > using the errdisable recovery command, are there any other methods? > > > > With regards > Kings > > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
