Hi,
This task says that you need to allow the traffic from the outside to the
loopback 222.222.222.222/32 on R2. The problem comes when it says that I need
to allow this using the Global ACL. There was already a Global ACL configured
but also, there are 2 access list on ASA3 used to allow traffic inbound from
outside at a previous task.
The problem is that even if I allow that traffic on the global ACL, it is not
going to work, as the interface ACL is processed first than the Global ACL.
Is there something that I am doing wrong?
Another question that comes up is that, for every object that needed to 2 NATs
for both outside interfaces, I created the Object and then another object with
the same host and created the NAT there. Just checking if that is correct.
Finally, on a task I read, you can re-used the object for the Access
list....well, I reused every Object that I could :P so I dont know if previous
that task, I needed to create a new object for the ACLs.
Mike.
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
