Thank you Piotr for the clarification Date: Fri, 24 May 2013 13:55:17 +0200 Subject: Re: [OSL | CCIE_Security] WB1 SEC10 From: [email protected] To: [email protected] CC: [email protected]
Hi 1. Because the command takes bytes, not bits. The last paragraph of the solution mentions that 2. This is for IPv6 3. IP Protocol 4 is IPIP, then 1 is ICMP, ICMP Type 8 is Echo Request Regards,--Piotr Kaluzny CCIE #25665 (Security), CCSP, CCNPSr. Technical Instructor - IPexpert, Inc. URL: http://www.IPexpert.com On Fri, May 24, 2013 at 1:13 PM, Ahmed Magdy <[email protected]> wrote: Hi , I have 3 question related to wb1 sec10 which I need some help to understand it: SEC 10 task 4:the burst values for IPV4, we are supposed to use 64kbps not 8kbps. the 3rd point"other IPV4 traffic should be rate-limited to 64kbps.Use 64 Kbps for both of the burst values"But in the solution he used 8 kbps for both of the burst values, aren't we supposed to use 64kbps? SEC 10 task 10 why do we need to set the connection limit under the class class-default , we already did that for the class TCP_UDP_Class. SEC 10 task 11:I am not fully understand how he configured R5 to drop the ICMP packets with "AZ" in the payload. Class-map type access-control match-all FPM_IPIP_CLASS match start l3-start offset 9 size 1 eq 4match start l3-start offset 29 size 1 eq 1match start l3-start offset 40 size 1 eq 8match start l3-start offset 44 size 100 regex ".* AZ.*" Thanks,Magdy _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
