no I didn't have I just use :
#ip address outside dhcp
Does this command "ip address dhcp setroute" if I used , will resolve the
problem?
Thanks,
Israa
________________________________
From: "[email protected]"
<[email protected]>
To: [email protected]
Sent: Tuesday, 2 July 2013, 19:00
Subject: CCIE_Security Digest, Vol 85, Issue 1
Send CCIE_Security mailing list submissions to
[email protected]
To subscribe or unsubscribe via the World Wide Web, visit
http://onlinestudylist.com/mailman/listinfo/ccie_security
or, via email, send a message with subject or body 'help' to
[email protected]
You can reach the person managing the list at
[email protected]
When replying, please edit your Subject line so it is more specific
than "Re: Contents of CCIE_Security digest..."
Today's Topics:
1. Re: Dynamic to Static IPSec VPN (Joe Astorino)
----------------------------------------------------------------------
Message: 1
Date: Mon, 1 Jul 2013 15:18:51 -0400
From: Joe Astorino <[email protected]>
To: cisco 2006 <[email protected]>
Cc: "[email protected]"
<[email protected]>
Subject: Re: [OSL | CCIE_Security] Dynamic to Static IPSec VPN
Message-ID:
<CAO+ThHQA=F8vGAsUhF+LJT7f=a6okeiiucb8jyu2ditp1sa...@mail.gmail.com>
Content-Type: text/plain; charset="iso-8859-1"
Do you have "ip address dhcp setroute" configured on the outside interface
of your remote PIX?
On Tue, Jun 25, 2013 at 8:18 AM, cisco 2006 <[email protected]> wrote:
> Dear all,
> I have a question about Dynamic to static IPsec VPN , that a remote PIX
> receives an IP address through Dynamic Host Configuration
> Protocol (DHCP) and connects to a central PIX. This configuration enables
> the central PIX to accept dynamic
> IPsec connections. The remote PIX uses network address translation (NAT)
> to "join" the privately addressed
> devices behind it to the privately addressed network behind the central
> PIX.
> I create a tunnel and every thing is going well . But the problem is that
> after a period of time the remote device that receives an IP address
> through DHCP , loses this command :
>
> route outside 0.0.0.0 0.0.0.0 192.168.20.1
>
> So that I lost the connection and I have to add it again in the remote PIX
> . This makes a lot of problem for our network.
> Please ,I need your advice to solve this problem .
>
> Best Regards,
> Israa Nema
>
> _______________________________________________
> For more information regarding industry leading CCIE Lab training, please
> visit www.ipexpert.com
>
> Are you a CCNP or CCIE and looking for a job? Check out
> www.PlatinumPlacement.com
>
--
Regards,
Joe Astorino
CCIE #24347
http://astorinonetworks.com/
"He not busy being born is busy dying" - Dylan
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
</archives/ccie_security/attachments/20130701/24af8edd/attachment-0001.html>
End of CCIE_Security Digest, Vol 85, Issue 1
********************************************
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
