Hey Piotr; When I first installed the WSA, I only Added 3 interfaces (its a vWSA), so when I go to interfaces, i only see the M1, p1 and p2. I dont see any T Interfaces.
I was wondering if there is a way to add another interface or do I have to re-install the WSA and add the needed interface. Sent from my iPhone On Jul 10, 2013, at 3:23 AM, "Piotr Kaluzny" <[email protected]> wrote: > Mike > > Not sure if this is what you are asking for but you can use "interfaceconfig" > to add P1/P2 to the mix. > > If you want to use L4TM just go under Network -> Interfaces; port should be > already activated. To modify physical settings for any port, including T1/T2, > use "etherconfig". > > Regards, > -- > Piotr Kaluzny > CCIE #25665 (Security), CCSP, CCNP > Sr. Technical Instructor - IPexpert, Inc. > URL: http://www.IPexpert.com > > > On Wed, Jul 10, 2013 at 2:56 AM, Mike Rojas <[email protected]> wrote: >> Hi, >> >> Is it possible to add a new interface on a already installed WSA? I need to >> add a T1 interface for the final part of the lab. >> >> Mike. >> >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com >> >> Are you a CCNP or CCIE and looking for a job? Check out >> www.PlatinumPlacement.com >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
