Did you check off status polling on the device config for the circuit?
On Feb 22, 2009, at 12:10 PM, Ryan Trauernicht wrote:
When you try this again what does Perfmon tell you the service of
the channels?
0, 1, 2, 3?
On Sun, Feb 22, 2009 at 11:07 AM, Robert Schuknecht <[email protected]
> wrote:
Hi List,
during my last Remote-Rack Sessions i noticed that the B-Channel
Maintenance Status Parameter is not workking properly. Always when i
configured it and restartet the CCM Srevice and the Gateway itself,
it is working for some calls. And suddenly the Gateway is trying to
call out over the not available B-Channels
I configured the Maintenance Status the following ways:
1) S0/ds...@sda000332333241=000111111111111111111111
2) S0/ds...@sda000332333241 = 000111111111111111111111
But both of them did not work. What am i doing wrong here?
/Robert
