I have not used the remote lab that you have. I have used the Proctor Labs remote equipment ad have not encountered any big delays in the CCM or UCM screen changes nor delays when working in the IOS devices.
Let me know if I can be of any further help. Larry Hadrava CCIE #12203 CCNP CCNA Sr. Support Engineer – IPexpert, Inc. URL: http://www.IPexpert.com On Mon, May 11, 2009 at 7:25 PM, junk cisco <[email protected]> wrote: > Thks Larry and Tech Guy, > > The reason I asked this, I used remote rack from InternetworkExpert, and > it behave differently from what the real CCM do. > > For example: > - GW will not register after u change the MAC (and change back again for > testing purpose) even after CCM restart and GW reset > - Can not use to register phone to SUBSCRIBER for redundant test > - very slow response to Call Manager screen, etc > > Did you guys not experience these or other issue when using the remote lab > ? that I think different from real Call Manager or maybe any workaround for > this VM cluster ? > > Thks, > > > > >* Even if you go to a lab location that the equipment is physically > there, > *>* you cannot touch it. It will generate noise near you. > *>* > *>* Other than that, you will be so focused on the config screens and the > lab* > >* book that you would probably not know if there was a rack of equipment > in > *>* the same room as you or not. > *>* > *>* As long as the rack that you are working on meets ALL of the current > lab > *>* requirements ( IOS versions, hardware platform, etc. ) you should be > fine > *>* without seeing it. > *>* > *>* Even when you take a bootcamp class, the equipment may or may not be > in the > *>* same location as where you are. If it is in the same location, most > likely, > *>* it will be in another room to isolate you from the distraction of the > noise > *>* and heat. > *>* > *>* Larry Hadrava > *>* CCIE #12203 CCNP CCNA > *>* Sr. Support Engineer – IPexpert, Inc. > *>* URL: http://www.IPexpert.com <http://www.ipexpert.com/> < > http://www.ipexpert.com/> > *
