If this is a cme-ccm call; also register ccm to the ios xcoder that you have configured and assign them to MRGL and then to the Device Pool of the phones in ccm.
Tech Guy ----- Original Message ----- From: jeremy co To: WorkerBee Cc: [email protected] Sent: Saturday, May 16, 2009 2:34 AM Subject: Re: [OSL | CCIE_Voice] 3rd day in raw ,Xcoder still wouldn't kick in. Hi, I registered them to CME. as sdspfarm show command depicted. Jeremy On Sat, May 16, 2009 at 12:51 PM, WorkerBee <[email protected]> wrote: Do you have the xcoder resources assigned to the phones correctly? MRGL? On Sat, May 16, 2009 at 3:55 AM, jeremy co <[email protected]> wrote: > Hi Guys, > > I have this issue for first time, dsp resources will not perform their job. > MTP registered,Router couple of times has been rebooted. I did "test dsp > device 1 1 reset" couple of times > > Here is my config : (to simplify testing ,I make this gateway h323 ,rigion > G729 , incoming dial-peer G711u) > > > sccp local FastEthernet0/0.11 > sccp ccm 142.4.64.114 identifier 1 > sccp > ! > sccp ccm group 1 > bind interface FastEthernet0/0.11 > associate ccm 1 priority 1 > associate profile 1 register MTP000cce1db0c0 > ! > dspfarm profile 1 transcode > codec g711ulaw > codec g711alaw > codec g729ar8 > codec g729abr8 > codec g729r8 > maximum sessions 4 > associate application SCCP > ! > ! > ! > dial-peer voice 1000 voip > incoming called-number . > codec g711ulaw > no vad > ! > ! > ! > ! > ! > telephony-service > ip source-address 142.4.64.114 port 2000 > sdspfarm units 1 > sdspfarm transcode sessions 4 > sdspfarm tag 1 MTP000cce1db0c0 > > ! > > C2600# sh sdsp sessions sum > > max-mtps:1, max-streams:8, alloc-streams:8, act-streams:0 > ID MTP State CallID confID Usage > Codec/Duration > ==== ===== ====== =========== ====== ============================= > ============== > 1 1 IDLE 0 0 > G711Ulaw64k /20ms > 2 1 IDLE 0 0 > G711Ulaw64k /20ms > 3 1 IDLE 0 0 > G711Ulaw64k /20ms > 4 1 IDLE 0 0 > G711Ulaw64k /20ms > 5 1 IDLE -1 0 > G711Ulaw64k /20ms > 6 1 IDLE -1 0 > G711Ulaw64k /20ms > 7 1 IDLE -1 0 > G711Ulaw64k /20ms > 8 1 IDLE -1 0 > G711Ulaw64k /20ms > > > C2600#sh sdspfarm units > > mtp-1 Device:MTP000cce1db0c0 TCP socket:[1] REGISTERED > actual_stream:8 max_stream 8 IP:142.4.64.114 44154 MTP YOKO keepalive 82 > Supported codec: G711Ulaw > G711Alaw > G729 > G729a > G729ab > > > > if I change incoming dial peer to G729 every thing is fine . so I don't have > call routing sisue. > > Anybody face this before? > > > Jeremy > > > > >
