It will work on both same gateway and also on separate gateway. From: Aamir Panjwani [mailto:[email protected]] Sent: Monday, 5 October 2009 2:57 PM To: Kumar, Narinder; Michael Ciarfello; OSL Group Subject: RE: [OSL | CCIE_Voice] MVA Issue
So you configured MVA VXML script on a separate gateway or on the same gateway where mgcp is configured? From: Kumar, Narinder [mailto:[email protected]] Sent: Monday, 5 October 2009 2:44 PM To: Michael Ciarfello; Aamir Panjwani; OSL Group Subject: RE: [OSL | CCIE_Voice] MVA Issue Thanks Michael, I did it and works fine. From: Michael Ciarfello [mailto:[email protected]] Sent: Monday, 5 October 2009 11:14 AM To: Kumar, Narinder; Aamir Panjwani; OSL Group Subject: RE: [OSL | CCIE_Voice] MVA Issue Convert it back to MGCP and practice the hairpinning mode also. I got it to work by putting MVA on the MGCP router. Little tricky, but the SRND or F&S guide gives great hints. Also practice it by putting MVA on a separate router that runs H323, maybe PSTN-WAN router if you have your own equipment. Not sure if you have access to it in the PLs. ________________________________ From: Kumar, Narinder [[email protected]] Sent: Sunday, October 04, 2009 5:16 AM To: Aamir Panjwani; Michael Ciarfello; OSL Group Subject: RE: [OSL | CCIE_Voice] MVA Issue Just fixed it, had issues with one of the dialpeer , as this gateway was earlier MGCP and I converted into H323 for MVA. Thanks all for help. From: Aamir Panjwani [mailto:[email protected]] Sent: Sunday, 4 October 2009 8:09 PM To: Kumar, Narinder; Michael Ciarfello; OSL Group Subject: RE: [OSL | CCIE_Voice] MVA Issue Make sure CSS (not rerouting CSS which is used for SNR) on the remote destination profile has visibility of internal DN's partition as well as PSTN route pattern partitions From: [email protected] [mailto:[email protected]] On Behalf Of Kumar, Narinder Sent: Sunday, 4 October 2009 7:29 PM To: Michael Ciarfello; OSL Group Subject: Re: [OSL | CCIE_Voice] MVA Issue It is question 5.12 in Lab 5 volume 1. I have bind command and all Dial Peer configured, I will check the CCAPI output. From: Michael Ciarfello [mailto:[email protected]] Sent: Sunday, 4 October 2009 5:27 PM To: Kumar, Narinder; OSL Group Subject: RE: [OSL | CCIE_Voice] MVA Issue Seemed if I didn't have the h323 gateway voip bind command on one of the interfaces, I got the same symptoms. The lab (volume2, lab 3) was using all MGCP (I think) and didn't put the h323 bind command on. That seemed to make a difference. Other than that, what does ccapi show? And what is your design look like. What question, what lab? ________________________________ From: [email protected] [[email protected]] On Behalf Of Kumar, Narinder [[email protected]] Sent: Saturday, October 03, 2009 11:51 PM To: OSL Group Subject: [OSL | CCIE_Voice] MVA Issue I am having some issues with MVA . When I dial in after keying in my pin number I can turn on or off mobility that is working fine but I can't dial out any number I try dialling internal numbers i.e 3001, 5001 and well as PSTN number as soon as finish dialling the number after pressing # the call drops. I tried changing the inbound CSS in the service parameter to " Remote destination profile + line calling search space" but no luck. Anyone have any pointers what I am doing wrong ? Thanks Narinder ________________________________ CONFIDENTIALITY - The information contained in this electronic mail message is confidential and is intended solely for the addressee(s). If you are not an authorised recipient of this message please contact UXC Getronics Australia immediately by reply email and destroy/delete this message from your computer. Any unauthorised form of reproduction of this message, or part thereof, is strictly prohibited. DISCLAIMER - Unless specifically indicated otherwise, the views and opinions expressed in this email are those of the sender and not UXC Getronics Australia. While we endeavour to protect our network from computer viruses, UXC Getronics Australia does not warrant that this email or any attachments are free of viruses or any other defects or errors. It is the duty of the recipient to virus scan and otherwise test any information contained in this email before loading onto any computer system. ________________________________ CONFIDENTIALITY - The information contained in this electronic mail message is confidential and is intended solely for the addressee(s). If you are not an authorised recipient of this message please contact UXC Getronics Australia immediately by reply email and destroy/delete this message from your computer. Any unauthorised form of reproduction of this message, or part thereof, is strictly prohibited. DISCLAIMER - Unless specifically indicated otherwise, the views and opinions expressed in this email are those of the sender and not UXC Getronics Australia. While we endeavour to protect our network from computer viruses, UXC Getronics Australia does not warrant that this email or any attachments are free of viruses or any other defects or errors. It is the duty of the recipient to virus scan and otherwise test any information contained in this email before loading onto any computer system. ______________________________________________________________________ This email has been scanned by the MessageLabs Email Security System. For more information please visit http://www.messagelabs.com/email ______________________________________________________________________ ________________________________ CONFIDENTIALITY - The information contained in this electronic mail message is confidential and is intended solely for the addressee(s). If you are not an authorised recipient of this message please contact UXC Getronics Australia immediately by reply email and destroy/delete this message from your computer. Any unauthorised form of reproduction of this message, or part thereof, is strictly prohibited. DISCLAIMER - Unless specifically indicated otherwise, the views and opinions expressed in this email are those of the sender and not UXC Getronics Australia. While we endeavour to protect our network from computer viruses, UXC Getronics Australia does not warrant that this email or any attachments are free of viruses or any other defects or errors. It is the duty of the recipient to virus scan and otherwise test any information contained in this email before loading onto any computer system. ________________________________ CONFIDENTIALITY - The information contained in this electronic mail message is confidential and is intended solely for the addressee(s). If you are not an authorised recipient of this message please contact UXC Getronics Australia immediately by reply email and destroy/delete this message from your computer. Any unauthorised form of reproduction of this message, or part thereof, is strictly prohibited. DISCLAIMER - Unless specifically indicated otherwise, the views and opinions expressed in this email are those of the sender and not UXC Getronics Australia. While we endeavour to protect our network from computer viruses, UXC Getronics Australia does not warrant that this email or any attachments are free of viruses or any other defects or errors. It is the duty of the recipient to virus scan and otherwise test any information contained in this email before loading onto any computer system. ______________________________________________________________________ This email has been scanned by the MessageLabs Email Security System. For more information please visit http://www.messagelabs.com/email ______________________________________________________________________ ________________________________ CONFIDENTIALITY - The information contained in this electronic mail message is confidential and is intended solely for the addressee(s). If you are not an authorised recipient of this message please contact UXC Getronics Australia immediately by reply email and destroy/delete this message from your computer. Any unauthorised form of reproduction of this message, or part thereof, is strictly prohibited. DISCLAIMER - Unless specifically indicated otherwise, the views and opinions expressed in this email are those of the sender and not UXC Getronics Australia. While we endeavour to protect our network from computer viruses, UXC Getronics Australia does not warrant that this email or any attachments are free of viruses or any other defects or errors. It is the duty of the recipient to virus scan and otherwise test any information contained in this email before loading onto any computer system.
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
