Hi Miron... thanks for you suggestion...I thought you might have been onto the solution but I do have the default gateway configured in CUE and I can ping the phones on the remote subnet (where there is no audio from CUE) when I ping from the CLI of CUE.
scd On Fri, Sep 17, 2010 at 7:15 PM, Miron Kobelski <[email protected]> wrote: > Hi, > > do you have the default gateway configured for CUE module? > Check if you have IP connectivity from CUE CLI to calling phone's subnet. > > regards > kobel > > On Sat, Sep 18, 2010 at 02:55, CCIE Voice <[email protected]> wrote: > >> All: >> >> When a G.729 call from an HQ phone to the BR2 CME phone CFNA's to CUE >> Pilot - the CUE prompt doesn't play (call appears to be connected bu no >> audio) and when looking at the tx/rx stats of the HQ calling phone - you can >> see it transmitting all day long and never receiving. This isn't a 1-way >> audio issue as calls from HQ to the BR3 phone that are answered work just >> fine. I know CUE is only G711 and I've configured transcoding. >> >> HQ Phone <---> HQ CUCM <----WAN----> BR3 - H.323 - CME <---> CME Phone >> <---> CUE >> >> When a G.729 call from an HQ phone to the BR2 CME phone CFNA's to CUE >> Pilot - the CUE prompt doesn't play (call appears to be connected bu no >> audio) and when looking at the tx/rx stats of the HQ calling phone - you can >> see it transmitting all day long and never receiving. This isn't a 1-way >> audio issue as calls from HQ to the BR3 phone that are answered work just >> fine. I know CUE is only G711 and I've configured transcoding. >> >> Any thoughts appreciated !! >> >> The call from the HQ phone going into CME hits this inbound dial-peer: >> ! >> dial-peer voice 3 voip >> description Handles incoming calls from VOIP peers >> voice-class codec 1 >> incoming called-number . >> no vad >> ! >> voice class codec 1 >> codec preference 1 g729r8 >> ! >> >> The call then hits this dial-peer outbound to route to CUE pilot: >> >> dial-peer voice 4220 voip >> destination-pattern 4220 >> session protocol sipv2 >> session target ipv4:(CUE ADDRESS) >> dtmf-relay sip-notify >> codec g711ulaw >> no vad >> >> My DSP configurations are: >> >> voice-card 0 >> no dspfarm >> dsp services dspfarm >> >> sccp local FastEthernet0/1.2 >> sccp ccm (CME ADDRESS) identifier 1 version 6.0 >> sccp >> ! >> sccp ccm group 1 >> associate ccm 1 priority 1 >> associate profile 2 register sc_conf >> associate profile 1 register sc_xcoder >> ! >> dspfarm profile 1 transcode >> codec g711ulaw >> codec g711alaw >> codec g729ar8 >> codec g729abr8 >> codec g729r8 >> maximum sessions 2 >> associate application SCCP >> >> telephony-service >> sdspfarm units 2 >> sdspfarm transcode sessions 4 >> sdspfarm tag 1 sc_xcoder >> sdspfarm tag 2 sc_conf >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com >> >> >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
