Do you have this GW configured on CUCM? Is the gateway showing registered on CUCM? Do you have mgcp configured/enabled on the router? Have you bounced the MGCP (no mgcp/mgcp) after configuring the pri?
You will see TEI Assigned until you have successfully configured all aspects of the MGCP GW. Jeff From: ccie_voice-boun...@onlinestudylist.com [mailto:ccie_voice-boun...@onlinestudylist.com] On Behalf Of Deepak sidana Sent: Thursday, January 06, 2011 1:25 PM To: ccie_voice@onlinestudylist.com Subject: [OSL | CCIE_Voice] T1 Pri Issue Hi All, I am trying to connect the T1 from Br1-RTR to PSTN-WAN. Only when i use service mgcp, under controller, layer 2 isdn staus as TEI_ASSIGNED. At PSTN-WAN Router, i am using "isdn protocol-emulate network" under s0/0/0:23 Branch1 Config:- BR1-RTR#sh isdn sta Global ISDN Switchtype = primary-net5 ISDN Serial0/0/0:23 interface dsl 0, interface ISDN Switchtype = primary-net5 Layer 1 Status: ACTIVE Layer 2 Status: TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED ! controller T1 0/0/1 framing esf linecode b8zs cablelength long 0db ! interface Serial0/0/0:23 no ip address encapsulation hdlc isdn switch-type primary-net5 isdn bind-l3 ccm-manager isdn incoming-voice voice no cdp enable Please share you experince, if some one faced the same issue. Thanks&Rgds Deepak Sidana.
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com