thanks, it was the codec I changed it and now is working. On Fri, Jul 1, 2011 at 7:57 AM, manishankar pandey <manishankar...@yahoo.com > wrote:
> Yes this has to do with Codec mismatch. Or the Interpretation of Fast start > and Slow start. > > Try using the below option > > 1) Create Voice class and then bind it to dial-peer > Example : > > voice class h323 1 > h225 timeout tcp establish 5 > h225 display-ie ccm-compatible > call start fast > ! > voice class h323 5 > h225 timeout tcp establish 5 > h225 display-ie ccm-compatible > call start interwork > ! > voice class h323 6 > h225 timeout tcp establish 5 > h225 display-ie ccm-compatible > call start slow > > And under Dial-peer VoIP, try testing with each Voice class h323 command > > " voice-class h323 "1/5/6" > Thanks > --- On *Fri, 7/1/11, Emin Guliyev <eguli...@fidelus.com>* wrote: > > > From: Emin Guliyev <eguli...@fidelus.com> > Subject: Re: [OSL | CCIE_Voice] CME to CUCM Via CUBE configuration > assistant > To: "Art Joe Babakhani Gharibian" <ciscoie2...@gmail.com>, " > ccie_voice@onlinestudylist.com" <ccie_voice@onlinestudylist.com> > Date: Friday, July 1, 2011, 6:01 PM > > > Looks like it is failing due to codec negotiation. > > > > Media negotiation failure > > Typical scenarios include: > > •[image: Description: http://www.cisco.com/en/US/i/templates/blank.gif]No > codec match occurred. > > •[image: Description: http://www.cisco.com/en/US/i/templates/blank.gif]H.323 > or H.245 problem leading to failure in media negotiation > > 65 > > CC_CAUSE_BEARER_CAPABILITY_ > NOT_IMPLEMENTED > > Indicates that the equipment sending this cause does not support the bearer > capability requested. > > > > Jun 29 21:49:46.402: //33/8A1D25B080B9/H323/cch323_h225_send_release: Cause > = 65; Location = 0 > > > > > > *From:* ccie_voice-boun...@onlinestudylist.com [mailto: > ccie_voice-boun...@onlinestudylist.com] *On Behalf Of *Art Joe Babakhani > Gharibian > *Sent:* Friday, July 01, 2011 12:47 AM > *To:* ccie_voice@onlinestudylist.com > *Subject:* [OSL | CCIE_Voice] CME to CUCM Via CUBE configuration assistant > > > > Has anyone tested a call from CME >> to >> CUCM via Gatekeeper and CUBE? > > Could you please provide a working configuration sample? > > I have configured the gatekeeper to send the calls from CME to CUCM via > CUBE. CME calls drop after matching an incoming voip dialpeer in the CUBE. > I can’t figure out why my calls get disconnected once they match an incoming > dial-peer. It is worth mentioning that I use that exact same dial-peers to > send calls from CUCM to CME and they work just fine. > > I am pasting some show and debug outputs. > > Thanks, > > Joe > > *ON the CUBE >> show run | s dial-peer * > > dial-peer voice 20 voip > > incoming called-number . > > dtmf-relay h245-alphanumeric > > no vad > > dial-peer voice 21 voip > > destination-pattern [1,3,5]... > > voice-class codec 1 > > session target ras > > dtmf-relay h245-alphanumeric > > no vad > > > > > > *show run | s gatek * > > gatekeeper > > zone local Spain ipexpert.com outvia VGK > > zone local US ipexpert.com outvia VGK > > zone local VGK ipexpert.com > > zone remote PSTN-WAN ipexpert.com 10.10.100.2 1719 > > zone prefix US 1... gw-priority 10 gk-trunk_1 > > zone prefix US 1... gw-priority 9 gk-trunk_2 > > zone prefix Spain 3... > > zone prefix US 5... gw-priority 10 gk-trunk_1 > > zone prefix US 5... gw-priority 9 gk-trunk_2 > > gw-type-prefix 1#* default-technology > > no shutdown > > > > *on the CUBE debug voice dialpeer * > > > > Jun 29 21:49:12.911: //-1/762755B380B3/DPM/dpAssociateIncomingPeerCore: > > Calling Number=3006, Called Number=5002, Voice-Interface=0x0, > > Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search > Type=PEER_TYPE_VOICE, > > Peer Info Type=DIALPEER_INFO_SPEECH > > Jun 29 21:49:12.911: //-1/762755B380B3/DPM/dpAssociateIncomingPeerCore: > > Result=Success(0) after DP_MATCH_INCOMING_DNIS; Incoming Dial-peer=20 > > Jun 29 21:49:12.911: //-1/762755B380B3/DPM/dpAssociateIncomingPeerCore: > > Calling Number=3006, Called Number=5002, Voice-Interface=0x0, > > Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search > Type=PEER_TYPE_VOICE, > > Peer Info Type=DIALPEER_INFO_SPEECH > > > > Jun 29 21:49:12.911: //-1/762755B380B3/DPM/dpAssociateIncomingPeerCore: > > Result=Success(0) after DP_MATCH_INCOMING_DNIS; Incoming Dial-peer=20 > > > > > > *On the CUBE >> debug cch323 h225 * > > > > Jun 29 21:49:46.398: //-1/xxxxxxxxxxxx/H323/cch323_h225_receiver: Received > msg of type SETUPIND_CHOSEN > > Jun 29 21:49:46.398: //-1/xxxxxxxxxxxx/H323/setup_ind: Entry > > Jun 29 21:49:46.398: //33/8A1D25B080B9/H323/setup_ind: callingNumber[3006] > calledNumber[5002] > > Jun 29 21:49:46.398: //33/8A1D25B080B9/H323/setup_ind: ---- calling IE > present > > Jun 29 21:49:46.398: //33/8A1D25B080B9/H323/setup_ind: ====== PI = 0 > > Jun 29 21:49:46.402: //33/8A1D25B080B9/H323/setup_ind: Receive: infoXCap 0 > > Jun 29 21:49:46.402: //33/8A1D25B080B9/H323/setup_ind: Receive: infoXCap > ccb 0 > > Jun 29 21:49:46.402: //33/8A1D25B080B9/H323/setup_ind: > > setup_ind: is_overlap = 0, info_complete = 0 > > > > Jun 29 21:49:46.402: //33/8A1D25B080B9/H323/cch323_h225_receiver: > SETUPIND_CHOSEN: src address = 10.10.200.3; dest address = 10.10.112.2 > > Jun 29 21:49:46.402: //33/8A1D25B080B9/H323/run_h225_sm: Received event > H225_EV_FS_SETUP_IND while at state H225_IDLE > > Jun 29 21:49:46.402: //33/8A1D25B080B9/H323/idle_fsSetupInd_hdlr: Setup ccb > 0x4A40CB50 > > Jun 29 21:49:46.402: //33/8A1D25B080B9/H323/act_fastStartSetupInd: full > match is found > > Jun 29 21:49:46.402: //33/8A1D25B080B9/H323/act_fastStartSetupInd: codec > match = 2 > > Jun 29 21:49:46.402: > //33/8A1D25B080B9/H323/cch323_create_incoming_callinfo_block: peer 4725E964, > voice_peer_tag 20, ccb: 4A40CB50 > > Jun 29 21:49:46.402: //33/8A1D25B080B9/H323/cch323_h225_send_release: Cause > = 65; Location = 0 > > Jun 29 21:49:46.406: //33/8A1D25B080B9/H323/cch323_h225_send_release: > h225TerminateRequest: src address = 168478723; dest address = 10.10.112.2 > > Jun 29 21:49:46.406: //33/8A1D25B080B9/H323/cch323_h225_set_new_state: > Changing from H225_IDLE state to H225_WAIT_FOR_REL_COMP state > > Jun 29 21:49:46.410: //33/8A1D25B080B9/H323/run_h225_sm: Received event > H225_EV_RELEASE_TIMER while at state H225_WAIT_FOR_REL_COMP > > Jun 29 21:49:46.410: //33/8A1D25B080B9/H323/cch323_h225_set_new_state: > Changing from H225_WAIT_FOR_REL_COMP state to H225_IDLE state > > > > Jun 29 21:49:46.414: //-1/xxxxxxxxxxxx/H323/validate_crv: No CCB for crv: > 0x801D > > > > *On The CUBE >> debug h225 q931* > > > > Protocol Discriminator : 0x08 > > CRV Length : 2 > > CRV Value : 0x0009 > > Message Type : 0x05: SETUP > > Bearer Capability: Length Of IE=3 > > Data 8090A3 > > Display: Length Of IE=9 > > Data 6272322070686E2034 > > Calling Party Number: Length Of IE=6 > > Data 008133303036 > > Called Party Number: Length Of IE=5 > > Data 8035303032 > > User-User: Length Of IE=176 > > Data > 0520A0060008914A0004014006004200520032002D00520054005228C0B50000120B436973636F47617465776179003240023C0504010020402C05010000FE55CEEAA2C411E0803A80B055C3ADAB00CD1D820007000A0A7002C7471100FE566B12A2C411E0803C80B055C3ADAB3402130000000C6013800B050001000A0A700241F3801E400000060401004C60138012150001000A0A700241F2000A0A700241F3800100010001800180010010800180 > > Q931 Message IE Decodes > > Protocol Discriminator : 0x08 > > CRV Length : 2 > > CRV Value : 0x8009 > > Message Type : 0x5A: RELEASE_COMP > > Cause: Length Of IE=2 > > Data 80C1 > > User-User: Length Of IE=34 > > Data 052580060008914A000411001100FE566B12A2C411E0803C80B055C3ADAB10800180 > > HQ-RTR# > > Q931 Message IE Decodes > > Protocol Discriminator : 0x08 > > CRV Length : 2 > > CRV Value : 0x0009 > > Message Type : 0x5A: RELEASE_COMP > > Cause: Length Of IE=2 > > Data 80C1 > > User-User: Length Of IE=34 > > Data 052580060008914A000411001100FE566B12A2C411E0803C80B055C3ADAB10800180 > -----Inline Attachment Follows----- > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > >
<<image001.png>>
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
![http://www.cisco.com/en/US/i/templates/blank.gif]No](http://www.cisco.com/en/US/i/templates/blank.gif]No){kind=link}
![http://www.cisco.com/en/US/i/templates/blank.gif]H.323](http://www.cisco.com/en/US/i/templates/blank.gif]H.323){kind=link}