Hello DeShon , this is correct but the point i was explaining is the fact that the IP-IP functionality will not need any media device to be allocated , you guys are talking about the media part of call which will be after the signaling negotiation part and the protocol translation ,
the CUBE will decide the decision about allocating any media device based on what is configured under the incoming and the outgoing dial-peers if no codec/dtmf mismatch detected then the call will go through without any media allocation Ash On Tue, Aug 23, 2011 at 2:32 PM, DeShon Crayton <[email protected]> wrote: > Software MTP will be used if you have SIP end points to ancor media > streams.. > > Also, transcoders will be used if SIP end points are set to g711 and the > CUBE is passing the call as g729. > > Last, you will need MTP to handle dtmf conversion for sip end points.. > > > > From: [email protected] > [mailto:[email protected]] On Behalf Of Dew Swen > Sent: Tuesday, August 23, 2011 4:28 AM > To: CCIE Voice Maillist > Subject: [OSL | CCIE_Voice] When DSP is used in CUBE ? > > > > Hi guys, > > When using CUBE, are DSP resoruces being used for these? > - h323 to sip (yes it is used) > - h323 to h323 ??? (is dsp used because of using MTP) > - sip to sip ??? (is dsp used because of using MTP) > > Kind regards, > > -- > Dew Swen > > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
