Make sure that you configured the codec under the dial peers on BR1. They use g729 by default. Sounds like the dial-peers to call manager from BR1 don't have a voice class codec or are a hard set codec configured.
Sent from my iPhone On Nov 30, 2011, at 8:12 AM, Rynard Coetzee <rynard.coet...@bytes.co.za> wrote: > Hi guys > > I have been struggling with this problem for most of the day now ,and I don`t > know what else I can check. The MoH works if I call from HQ branch to BR1 > ,but when I call from the PSTN to BR1 I get tone on hold. I have the relevant > config on my BR1 router > > Ccm-manager music-on-hold > > Telephony service > > Moh music-on-hold.au > > Multicast moh 239.1.1.1 port 16384 route 10.10.110.2 (loopback) 10.10.201.1 > (Voice Int) > > I also configured separate DP for MOH server in CUCM with a G711 only region. > I have the MOH setting on the audio source ,server and MRG set. Another > strange thing that I see is when I call from HQ phone to BR1 phone and I put > BR1 phone on hold I hear the MOH stream ,but when I do show ccm-manager > music-on-hold it shows that there are 0 active multicast sessions ? > > Any ideas ,because I have run out … ? > Regards > > Rynard > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com