Errol, Do you have enough DSP resources for both channels?
*Emanuel Damasceno* On Sat, Dec 3, 2011 at 1:27 AM, Bill Lake <[email protected]> wrote: > what version of IOS do you have on this router? > > On Fri, Dec 2, 2011 at 5:20 PM, Errol Abrahams <[email protected]>wrote: > >> Hi All, >> >> I have a Cisco 2811 router with a VWIC-2MFT-T1 card and during bootup >> time, only the one channel T1 0/1/0 becomes active. The other channel which >> is T1 0/1/1 doesn't respond, but yet the 'AL' led on the card stays on. If >> I shut down the controller T1 0/1/0 then this channel responds but not the >> other one. Is there a command on the Cisco 2811 to active the other channel. >> >> I would appreciate your responds regarding this matter......thnx. >> >> Cheers >> >> Errol >> >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com >> >> Are you a CCNP or CCIE and looking for a job? Check out >> www.PlatinumPlacement.com >> > > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
