Thanks for the follow up. I had to do a service module restart Randall
Sent from my iPhone On Dec 11, 2011, at 10:09 PM, Ashraf Ayyash <ash.ayy...@gmail.com> wrote: > what is the status of this module ? > > ser ser 0/0 status , reset ..play with it a lil bit , make sure you > have the CUE SW installed > > Ash > > On Sun, Dec 11, 2011 at 6:30 PM, Randall Crumm <rrcr...@yahoo.com> wrote: >> HI, >> I have an issue with my CUE. I have the configuration on the SC rtr (see >> below). >> When I enter ser ser 0/0 ses I just get blank ... >> I hit ctl+alt+6 x and get back to the sc rtr cli >> >> If I hit enter again I get : >> SiteC-RTR# >> [Resuming connection 1 to 10.10.115.1 ... ] >> This is blank space... >> >> >> >> interface Loopback1 >> ip address 10.10.115.1 255.255.255.0 >> ip ospf network point-to-point >> ! >> interface Service-Engine0/0 >> ip unnumbered Loopback1 >> service-module ip address 10.10.115.2 255.255.255.0 >> service-module ip default-gateway 10.10.115.1 >> >> ip route 10.10.115.2 255.255.255.255 Service-Engine0/0 >> >> >> Thanks, >> Randall >> >> >> _______________________________________________ >> For more information regarding industry leading CCIE Lab training, please >> visit www.ipexpert.com >> >> Are you a CCNP or CCIE and looking for a job? Check out >> www.PlatinumPlacement.com _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com