Hi Krishna, you will not see Cos 5 in Threshold 1 because this is the default Threshold for Cos 5. The running-config presents always only the non-default values, e.g if you put an prefererence command on your dial-peers you will this only as long as it is not the default value 0.
Regards Steffen 2012/10/14 Krishna <vinayak_...@yahoo.com> > hi guys, > > i was wondering whether i am doing right way of doing lan qos or not ?? > the requirements are assign cos 5 to priority queue , cos 3 4 to queue 2 > with 60% exceed of cos 4 should be dropped. so here is my configuration for > that > > mls qos > mls qos srr-queue output cos-map queue 1 threshold 1 5 > mls qos srr-queue output cos-map queue 2 threshold 2 3 > mls qos srr-queue output cos-map queue 2 threshold 1 4 > > mls qos queue-set output 2 threshold 3 60 100 100 272 > > when i issued show run | i mls commands, i see every mls qos command > except the cos 5 which is assigned to q1 t1. Is my approach is correct in > dealing this question correctly?? does it matter whether we assign cos > values to t1 or t2 or t3 in the queues??? > > your input is much appreciated. > > thank you > krishna. > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
