Yes i am using g729 and i configured them from both sides CUCM side as region and location /devicepool and voice class codec as cme side. I am able to send calls from CME to CUCM but cucm unable to place calls to CME
On Feb 17, 2013, at 3:51 PM, Cory Gray <[email protected]> wrote: > Should not have allow connections either unless you are doing cube but that > should not break it. Debug h22r ans1 and look to see if there is detail on > why the call is failing. Make sure you are using g729 as well > > Sent from my iPhone > > On Feb 17, 2013, at 5:39 PM, "Hesham Abdelkereem" <[email protected]> > wrote: > >> I did that and allow connections as well >> >> On Feb 17, 2013, at 3:21 PM, Cory Gray <[email protected]> wrote: >> >>> Not sure if this is what is breaking it but you should not have voice class >>> h323 1 on your ras dialpeer on site c >>> >>> Sent from my iPhone >>> >>> On Feb 17, 2013, at 4:59 PM, "Hesham Abdelkereem" >>> <[email protected]> wrote: >>> >>>> Dear All, >>>> >>>> >>>> I have tried to configure a gatekeeper between HQ-SC for interoperability >>>> between CME and HQ >>>> The issue is I am just able to call from CME to CUCM but Unable to call >>>> from CUCM to CME. >>>> Knowing that I have created a Device Pool , Route Pattern , Gatekeeper >>>> info , Gatekeeper controlled trunk for Gatekeeper to call CME from CUCM >>>> Side >>>> when I debug i always get ARJ Admission Rejection. >>>> I don't want to change anything in the technology prefix or anything. >>>> I don't want to use default technology prefix. >>>> I want show gatekeeper endpoints and show gatekeeper gw-type-prefix to be >>>> the same exactly. >>>> I just want to troubleshoot the issue of calling from CUCM to CME. >>>> Thank you so much for all your efforts >>>> >>>> >>>> However, here you are my configs >>>> >>>> GATEKEEPER HQ Router - SIDE >>>> >>>> voice service voip >>>> allow-connections h323 to h323 >>>> allow-connections h323 to sip >>>> allow-connections sip to h323 >>>> allow-connections sip to sip >>>> >>>> interface Loopback0 >>>> ip address 177.1.254.1 255.255.255.255 >>>> h323-gateway voip bind srcaddr 177.1.254.1 >>>> >>>> gatekeeper >>>> zone local CUCM cisco.com 177.1.254.1 >>>> zone local CUCME cisco.com >>>> zone prefix CUCM 1... >>>> zone prefix CUCM 2... >>>> zone prefix CUCME 3... >>>> gw-type-prefix 1* >>>> no shutdown >>>> >>>> >>>> >>>> >>>> SC Side >>>> >>>> interface Loopback0 >>>> ip address 177.1.254.3 255.255.255.255 >>>> h323-gateway voip interface >>>> h323-gateway voip id CUCM ipaddr 177.1.254.1 1719 >>>> h323-gateway voip h323-id CUCME >>>> h323-gateway voip tech-prefix 31 >>>> h323-gateway voip bind srcaddr 177.1.254.3 >>>> >>>> >>>> dial-peer voice 85 voip >>>> destination-pattern [12]...$ >>>> voice-class h323 1 >>>> session target ras >>>> dtmf-relay h245-alphanumeric >>>> >>>> >>>> CorpHQ(config-dial-peer)#do show gatekeeper end >>>> GATEKEEPER ENDPOINT REGISTRATION >>>> ================================ >>>> CallSignalAddr Port RASSignalAddr Port Zone Name Type Flags >>>> --------------- ----- --------------- ----- --------- ---- ----- >>>> 177.1.10.10 1720 177.1.10.10 32811 CUCM VOIP-GW >>>> H323-ID: CUCM_TRUNK_1 >>>> Voice Capacity Max.= Avail.= Current.= 0 >>>> 177.1.10.20 1720 177.1.10.20 32788 CUCM VOIP-GW >>>> H323-ID: CUCM_TRUNK_2 >>>> Voice Capacity Max.= Avail.= Current.= 0 >>>> 177.1.254.3 1720 177.1.254.3 63360 CUCM H323-GW >>>> H323-ID: CUCME >>>> Voice Capacity Max.= Avail.= Current.= 0 >>>> Total number of active registrations = 3 >>>> >>>> CorpHQ(config-dial-peer)# >>>> >>>> >>>> CorpHQ(config-dial-peer)#do show gatekeeper gw-type-prefix >>>> GATEWAY TYPE PREFIX TABLE >>>> ========================= >>>> Prefix: 31* >>>> Zone CUCM master gateway list: >>>> 177.1.254.3:1720 CUCME >>>> >>>> Prefix: 1* >>>> Zone CUCM master gateway list: >>>> 177.1.10.10:1720 CUCM_TRUNK_1 >>>> 177.1.10.20:1720 CUCM_TRUNK_2 >>>> >>>> >>>> CorpHQ(config-dial-peer)# >>>> _______________________________________________ >>>> For more information regarding industry leading CCIE Lab training, please >>>> visit www.ipexpert.com >>>> >>>> Are you a CCNP or CCIE and looking for a job? Check out >>>> www.PlatinumPlacement.com >> _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
