Hello experts, I'm having some trouble with the BACD dial-peer in vol 1 WB section 9.2. I'm following the CUCME BACD 'tcl in flash mem' guide as recommended by Vik but I'm getting fast busy when dialing into the aa. If I bring up a POTS dial-peer for PSTN->AA or if I modify session target to ras in the voip dial-peer for IP Phone->AA, the aa works so I at least know that part is solid.
Here's the dial-peer config I'm using that isn't working: dial-peer voice 222 voip service aa destination-pattern 3500 session target ipv4:10.10.110.3 incoming called-number 3500 dtmf-relay h245-alphanumeric codec g711ulaw no vad Also: allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connections sip to sip And a snip from the end of a voip dialpeer debug: Apr 24 00:52:24.603: //-1/xxxxxxxxxxxx/DPM/dpAssociateIncomingPeerCore: Calling Number=3500, Called Number=, Voice-Interface=0x0, Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search Type=PEER_TYPE_VOICE, Peer Info Type=DIALPEER_INFO_SPEECH Apr 24 00:52:24.603: //-1/xxxxxxxxxxxx/DPM/dpAssociateIncomingPeerCore: Result=Success(0) after DP_MATCH_ORIGINATE; Incoming Dial-peer=222 Apr 24 00:52:24.623: //-1/xxxxxxxxxxxx/DPM/dpAssociateIncomingPeerCore: Calling Number=3006, Called Number=, Voice-Interface=0x0, Timeout=TRUE, Peer Encap Type=ENCAP_VOIP, Peer Search Type=PEER_TYPE_VOICE, Peer Info Type=DIALPEER_INFO_SPEECH Apr 24 00:52:24.623: //-1/xxxxxxxxxxxx/DPM/dpAssociateIncomingPeerCore: Result=Success(0) after DP_MATCH_ORIGINATE; Incoming Dial-peer=40001-dial-peer)# I see in the debug it matches 222 as the inbound dial-peer but then it also matches 40001 for the SIP CME phone. Any help is much appreciated. Marty
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
