Hey Kristjan, For the bridge-groups all you need to do is type the config that you had below and the system will auto populate all of the rest of the config. Put in your config and do a show run to validate.
Thanks, -Kara -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Kristján Ólafur Eðvarðsson Sent: Thursday, January 20, 2011 8:41 AM To: [email protected] Subject: [CCIE Wireless] Autonmous CLI Hey guys and girl(s), I try only to use CLI in the autonomous section. I have been wondering if some of the extra commands that the WEB GUI adds when using that. For example. Creating vlans and subinterfaces. ! interface Dot11Radio1.114 encapsulation dot1Q 114 no ip route-cache bridge-group 114 bridge-group 114 subscriber-loop-control bridge-group 114 block-unknown-source no bridge-group 114 source-learning no bridge-group 114 unicast-flooding bridge-group 114 spanning-disabled ! interface FastEthernet0 no ip address no ip route-cache duplex auto speed auto bridge-group 1 no bridge-group 1 source-learning bridge-group 1 spanning-disabled ! interface FastEthernet0.114 encapsulation dot1Q 114 no ip route-cache bridge-group 114 no bridge-group 114 source-learning bridge-group 114 spanning-disabled ! But according to some configuration guides. And what I usually do is just: ! interface Dot11Radio1.114 encapsulation dot1Q 114 bridge-group 114 ! and the same with fastethernet0.114 ! Speed is a requirement in the LAB exam so I want do do without extra commands. I am just worried if the grading of the exam would require the source-learning and spanning-disabled. I might just look them up and post another mail that explains what they do. ! Also in local radius the EAP FAST parameters don´t seem to matter. Without them EAP-FAST works fine. Any comments on this ? regards. Kristjan _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
