Good work! I'll just add a couple of points to that: 1) The WLAN (Guest-LAN) must be disabled when you assign the anchor. So, configure the Guest-LAN, set the anchor, then enable the Guest-LAN. 2) Configuring the ingress interface using the CLI on the DMZ controller is one way of setting it to "None." You can also do it using the GUI. However, you will get an error message, which you can ignore. But, if you don't like error messages, use the CLI :)
Jason Boyers - CCIE #26024 (Wireless) Technical Instructor - IPexpert, Inc. Mailto: *[email protected] * On Tue, Apr 26, 2011 at 11:47 PM, Yuri Mecca <[email protected]> wrote: > Hey Guys, > > I just solved, just for record, thats is the config that works for me: > > DMZ: Guest LAN NAME: 90_99 (Ingress NONE, Egress 99) Anchor self. > WLC1: Guest LAN NAME: 90_99 (Ingress 90, Egress Management) Anchor DMZ. > > So, the trick for me is to setup the None as ingress in the DMZ Controller. > The GUI don't allow me. I need to setup it in the CLI, using this command: > > config guest-lan ingress-interface 1 none > > Thats work fine! I can authenticate and get access to the SW2 Web > interface. > > Best Regards, > > Yuri > > ------------------------------ > From: [email protected] > To: [email protected] > Subject: Guest LAN + Anchor > Date: Wed, 27 Apr 2011 00:22:24 -0300 > > > Hi guys, > > Work today in the Guest Lan + Anchor. > > I think I'm doing some mistake. > > I'm using the two 4402 from the Proctorlabs, where the first one is called > DMZ, the seccond one is called WLC1. > > I create a Guest Lan in the WLC1 with ingress vlan90 and egress management > and anchor it to DMZ. > In the DMZ I create another Guest Lan, same name, with ingress 90 and > egress 99. So when I setup the "auto-anchor" the ssid comes disable and I > saw this message in the console: Request failed - Ingress interface should > be cleared from guest LAN for mobility anchor wlc. > > Did I some mistake? Anyone work in that? > > Best Regards, > > Yuri > > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com <http://www.platinumplacement.com/> > >
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
