Just to add to the last post. There were questions how you would test clean air. I find in most situation that I have tested it with the highest sensivity I get some EDRRM changes, and it nice to see the alarm in WCS to see it why it was changed.
If you want an extreme test you can of course always test or AP near a Microwave oven and run it for a while. Most microwave ovens impact channels 6 and up so perhaps having an AP on those channels would give you the worst case that you are after. I think the frequency can be seen on back of some of the ovens to tell what frequency it is actually running. for example it would say 2,450 it would be close to 9 so perhaps try to trick RRM to set the AP as channel 11. (or enable DCA channel 9 only for a while and then enable others after the AP changes to 9, and then enable others for the AP to escape to for EDRRM) Manually setting it and enabling RRM again (global) might work. I haven´t actually gone so far to test it this way.... That is at least an idea on how you can do some damage to your AQI :D regards. Kristjan _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
