Of course there is a Layer 3 interface on a 2960. You always need one for management, telnet, etc...
Not sure what your issue is?? From: [email protected] [mailto:[email protected]] On Behalf Of alister magee Sent: 03 January 2014 07:44 To: Davar Bajelan; [email protected] Subject: Re: [OSL | CCIE_Wireless] NTP on 2960 switch Even if you write ntp broadcast client you required L3 interface but in 2960 switch there is no L3 interface :) I waste my 40 mins to search :) no issues i believe L3 interface is the only solution for it. On Fri, Jan 3, 2014 at 4:56 AM, Davar Bajelan <[email protected]<mailto:[email protected]>> wrote: Hi Alister, As per Cisco Lab Exam v2.0 - Lab Equipment and Software list the 2960 switch uses IOS Software Release 12.2 SE feature LAN BASE feature set not the ver 15.x https://learningnetwork.cisco.com/docs/DOC-5278 I have ver 12.2 does support broadcast. Davar On Thu, Jan 2, 2014 at 2:20 PM, alister magee <[email protected]<mailto:[email protected]>> wrote: Hi Davar, In my scenerio there is nothing mentioned about do not allowed to configure SVI but even it is not said you can configure any L3 interface to achieve the task :) I tried the option of ntp broadcast and ntp multicast but 2960 15.x switch do not take this commands. On Fri, Jan 3, 2014 at 3:45 AM, Davar Bajelan <[email protected]<mailto:[email protected]>> wrote: If you are not allowed to assigned IP address to your L2 switch ( not allowed to configure SVI) then you can try to use multicast: ntp multicast client [ip-address] On Thu, Jan 2, 2014 at 2:03 PM, Andre Aubet <[email protected]<mailto:[email protected]>> wrote: Hi Alister, As any device, a L2 switch has to have an ip address to be able to reach an external resource via IP. You have to configure an SVI and a default-gateway in the vlan which suits you, for your 2960 to reach 1.1.1.1 Only there will you be able to sync with the NTP server. Hope this is clear enough...? 2014/1/2 alister magee <[email protected]<mailto:[email protected]>> Hi, I have a general question i have 6501-A connected , 6501-B connected in central site I have 2960 switch connected with L2 there is no L3 interface on it Now if i need to run ntp on all the 3 switches what is the commands Lets assume my NTP address is 1.1.1.1 >From 6501A/B has L3 interface and it is routeable to 1.1.1.1 so its sync >properly But 2960 switch is L2 interface it has no connectivity or route to reach 1.1.1.1 So what is the procedure to break this? :) I am sorry it is not related to IPX workbook but general design i was reading somewhere and its very interesting question to understand. If anyone worked or working on it let me know Cheers. _______________________________________________ Free CCIE R&S, Collaboration, Data Center, Wireless & Security Videos :: iPexpert on YouTube: www.youtube.com/ipexpertinc<http://www.youtube.com/ipexpertinc> _______________________________________________ Free CCIE R&S, Collaboration, Data Center, Wireless & Security Videos :: iPexpert on YouTube: www.youtube.com/ipexpertinc<http://www.youtube.com/ipexpertinc>
_______________________________________________ Free CCIE R&S, Collaboration, Data Center, Wireless & Security Videos :: iPexpert on YouTube: www.youtube.com/ipexpertinc
