Hi Kendall:
I haven't used CCP4Mg^2+ but if it is launched by a shell script that
dumbly sets the DISPLAY variable, then on 10.5 this is equivalent to a
suicide directive, since the new X11 (as of 10.5) sets the DISPLAY
variable using launchd. If this is the case, hack that line out of
the script or put in a conditional test for the operating system
version.
The latest X11 for 10.5.4 is worth getting too, as it has a lot of
improvements:
http://xquartz.macosforge.org/trac/wiki/X112.3.0
Bill
William G. Scott
Contact info:
http://chemistry.ucsc.edu/~wgscott/
On Jul 25, 2008, at 9:18 AM, Kendall Nettles wrote:
CCPMG is launching X11 right before it quits. Could it relate to the
version
of X11? Coot was not working with the version that updates with the
OSX, so
I had to install the Xquartz version to get Coot to work.
Kendall
On 7/25/08 10:53 AM, "Jendrek" <[EMAIL PROTECTED]> wrote:
Hi,
I've had the same problem and discovered that in order to start
CCP4MG the
X11
must be closed.
So, just quit your X11 and then start again. It worked fine for me.
Andrzej
Kendall Nettles wrote:
I have tried installing the newest version of CCP4MG 1.1.1, the
closedirfix
version, and QtMG 1.99.0. In each case, the program does not
start. I did
get a problem report for pyton, shown below.
Mac ppc dual 2.7 GHz, OSX 10.5.4
X11= XQuartz 2.3.0(xorg-server 1.4.2-apple5)
Any suggestions would be greatly appreciated!
Kendall
