Hi Tim,
thankyou very much for the fast reply.
Dear colleagues,
Tim suggested:
>Hi Klaas
...
>Actually, you don't need to install arpwarp through the ccp4i interface.
>Once you setup your ccp4 environment, you can just run the install.sh (or
>install.csh in your case) which is in the arp-warp directory and
>everything should be set up for you.
>Tim
Been there, done that. Ain't working.
To be more specific, the installer is required to set up ARP/wARP, appears to
run flawlessly and ends with lots of "ok" messages. Finally the script
terminates with the remark:
Installing GUI for ARP/wARP 7.0.1
CCP4 interface version detected is : 2.0.3
Using tarball ARP_wARP_CCP4I6.tar.gz (for ccp4 version 6 and newer).
*** INSTALLATION OF ARP/wARP 7.0.1 GUI HAS BEEN SUCCESSFUL ***
When I now try to run a ARP/wARP task in CCP4i after sourcing the
arpwarp_setup.csh, I get the message: An interface to ARP/wARP is not
available. The ARP/wARP interface doesn't appear to have been installed.
Any further suggestions are most welcome.
Cheers,
Klaas
---
Dr. Klaas Max
MDC Berlin Buch
Macromolecular Structures and Interactions
Robert-Roessle-Strasse 10
13125 Berlin
phone +49 30 9406 2265
fax +49 30 9406 2548
---
