Hi Yuri, If you have access to mogul you can get an understanding of what your geometry should be based on the small molecule database. Of course not everything is well represented so if your ligand is unusual this will flag up in lower statistical significance.
Mogul will allow you to understand how far you are from ideal. Not really sure if this is what you might be after.... Joe P -------------------------------------------------------------------------- AstraZeneca UK Limited is a company incorporated in England and Wales with registered number: 03674842 and a registered office at 2 Kingdom Street, London, W2 6BD. Confidentiality Notice: This message is private and may contain confidential, proprietary and legally privileged information. If you have received this message in error, please notify us and remove it from your system and note that you must not copy, distribute or take any action in reliance on it. Any unauthorised use or disclosure of the contents of this message is not permitted and may be unlawful. Disclaimer: Email messages may be subject to delays, interception, non-delivery and unauthorised alterations. Therefore, information expressed in this message is not given or endorsed by AstraZeneca UK Limited unless otherwise notified by an authorised representative independent of this message. No contractual relationship is created by this message by any person unless specifically indicated by agreement in writing other than email. Monitoring: AstraZeneca UK Limited may monitor email traffic data and content for the purposes of the prevention and detection of crime, ensuring the security of our computer systems and checking Compliance with our Code of Conduct and Policies. -----Original Message----- From: CCP4 bulletin board [mailto:[email protected]] On Behalf Of Yuri Pompeu Sent: 12 September 2012 19:45 To: [email protected] Subject: [ccp4bb] Ligand geometry obs. vs. ideal Hi everyone, I am trying to show that a ligand underwent catalysis during a soaking experiment. One of the things I would like to show is the geometry of the ligand, bond angles/lengths, dihedrals, etc... One of my models has a hi-res of 1.18A and the ligand density is really clear and complete. What is the best way to refine the ligand unrestrained and then generate measurements? Also, the idea is to finally compare to ideal geometry. How should I generate these values (any softwares in mind)? ANy idea is welcome. Thanks a lot
