Try contacting Arthur Olson at Scripps (olson at scripps.edu).
He has done 3-D printing of molecular models for quite some time
now.
Frances
=====================================================
**** Bernstein + Sons
* * Information Systems Consultants
**** 5 Brewster Lane, Bellport, NY 11713-2803
* * ***
**** * Frances C. Bernstein
* *** [email protected]
*** *
* *** 1-631-286-1339 FAX: 1-631-286-1999
=====================================================
On Mon, 26 Nov 2012, Mike Lawrence wrote:
Hi,
Apologies for the off-topic question, but does anyone have any experience in
using the Cubify 3D printer (http://www.cubify.com/) for printing protein
models? Are the models robust? Is the resolution sufficient? The unit price
suggests that the printer is very low-end (though the consumables are not that
cheap).
sincerely
Mike Lawrence
Associate Professor and WEHI Fellow
Division of Structural Biology
Walter and Eliza Hall Institute of Medical Research
1G Royal Parade, Parkville
Victoria 3052, AUSTRALIA
Tel. 61-3-9345-2693
Fax 61-3-9345-2686
Email: [email protected]
______________________________________________________________________
The information in this email is confidential and intended solely for the
addressee.
You must not disclose, forward, print or use it without the permission of the
sender.
______________________________________________________________________
