Or you can give ccp4mg a go (see the ccp4 website). Makes wonderful pictures.
(shameless plug from yorkie) Johan On 13 March 2013 08:45, <[email protected]> wrote: > ** > Dear Tiantian, > > If it is for a picture for a publication, I would use Pymol. I find the > pictures prettier and you can specify any contour level you want. If > needed, I can provide you with some commands. > > Herman > > ------------------------------ > *From:* CCP4 bulletin board [mailto:[email protected]] *On Behalf Of * > ChenTiantian > *Sent:* Wednesday, March 13, 2013 9:33 AM > *To:* [email protected] > *Subject:* [ccp4bb] How to set the contour level to a specific value in > COOT? > > Hi there, > > I'm making an OMIT map figure with COOT, and I want to set the contour > level to a specific value, say, 2.0. > Since the initial value is not a whole number, I cannot manage it by > scrolling the wheel. Can I change this value by scripting or something like > that? > > Thanks in advance. > -- > Tiantian > ****************************************************************** > LIFE LIBERTY AND THE PURSUIT OF HAPPINESS > ****************************************************************** > > -- Dr. Johan P. Turkenburg X-ray facilities manager York Structural Biology Laboratory University of York Phone (+) 44 1904 328251 York YO10 5DD UK Fax (+) 44 1904 328266 Note new email address [email protected]
