-----Oorspronkelijk bericht-----
From: jwsmobile
Sent: Monday, November 09, 2015 9:13 PM
To: General Discussion: On-Topic and Off-Topic Posts
Subject: Re: PDP 11/03
I am mainly asking if I want to hook up a terminal, can I get it
going with TD, RD and GND (or 2 3 7 on a DB25), or do I need
to loop back any of the other pins. Also I will have to figure out
the serial settings, as Dec was fond of even parity, and so forth.
As far as my limited PDP-11 knowledge goes, none of them used
handshake. So, Rxd, TxD and GND is all you need to connect.
Also, common (?) is *no* parity.
- Henk
