On 2/8/16 11:53 AM, Al Kossow wrote:
On 2/8/16 10:09 AM, Guy Sotomayor wrote:
So, things are moving forward. I also wanted to get folk's opinion
on the need to actually produce
an SBC form factor board. In other words (and sort of in line with
how peripherals were done on the
original 11/20) is it OK to have the MEM11 be outside of the 11/20
chassis and connect via BC11A
(my replica) cables?
main problem would be now you'll have to come up with a box and a
power supply
As Ian stated in a subsequent post, it'll probably be something like a
1U box with appropriate power
supply. When I get to the point of doing serious board layout, then
I'll start looking at board outlines
(with appropriate mounting holes and power supply connectors) that would
fit in a reasonable
enclosure.
I'm hoping that my "prototype" will be sufficient where I don't need to
re-layout the board for
production. There may be extra pads for stuff (various test
connectors/test points) that won't
be stuffed for production...but that's all a bit down the road.
I assume you meant SPC (quad unibus) and not SBC
Yes, typo! :-(
TTFN - Guy
