-----Original Message----- From: cctalk [mailto:cctalk-boun...@classiccmp.org] On Behalf Of Al Kossow Sent: Sunday, May 29, 2016 3:00 PM To: cctalk@classiccmp.org Subject: Re: TU58 yet one more time.
On 5/29/16 11:34 AM, Mark J. Blair wrote: > My first attempt to use silicone tubing to repair my TU58 rollers was also unsuccessful. Maybe the material I used is too soft? Your experience suggests to me that I should hook up an oscilloscope to measure bit timing, and then adjust the roller composition and diameter to arrive close to the correct bit length. > > dug this up from the cctlk archive -- http://www.usplastic.com/catalog/item.aspx?itemid=23485 It just says "norprene A-60-F" the outside. It measures 3/8" I.D. I think other's have said 7/16" i.d., but I could not find that. I know I bought it from US Plastics and it's A-60-F. You have to buy 10' but its not very expensive. -brad ----- "A-60-F" would be here? http://www.usplastic.com/catalog/item.aspx?itemid=23886 $26.95 for 10 foot length. Ouch! 3/8" ID x 5/8" OD x 1/8" Wall TygonR A-60-F Hot Food & Beverage Tubing -----