These settings work for a DL-11 M7800 9600b console serial port.
Real Time option 540677 5008775B c29 open/out (not 110 baud) c31 open/out (not 100 baud) NP-U out (=no parity/disabled) 2SB-U out (2 Stop Bits) 2SB-U out (2 SB) EPS out (EPS=even parity when NP is jumrd) NB1/NB2 these two are set together both open = 8 databits. receive crystal 4 o'clock / pos 8 xmit crystal 4 o'clock / pos 8 4608 khz 9600 baud vector address jumper V V7 V6 V5 V4 V3 N 0 0 0 1 1 0 1 address jumpers A3 A4 A5 A6 A7 A8 A9 1 0 0 0 1 0 0 J1 J2 J3 1 0 1 On Sun, Jun 26, 2016 at 5:58 PM, william degnan <[email protected]> wrote: > > > On Sun, Jun 26, 2016 at 5:48 PM, Noel Chiappa <[email protected]> > wrote: > >> > From: Fritz Mueller >> >> > So far I haven't seen any place in PDP11GUI to set anything other >> than >> > port and baud rate >> >> You might have to use native OS tools to do that. On Unix, that will be >> 'stty'; on Windows, you'd have to use native Windows tools to do that; if >> you >> go to the Device Manager, select your serial port, and click on >> 'Properties', >> it has a tab ('Port Settings') for that (or, should I say, it used to - >> not >> sure about the most recent versions, they're making it all smart-phone >> like >> for brain-dead lusers). >> >> > My issue (M9312) has been that I can't get XXDP output to the screen, but > I can run the CONSOLE and initiate comms to and from the computer using > CONSOLE. When I run a XXDP routine I don't see anything to the screen so > far, regardless of what switch setting I am using. > > Specifically > > > http://bitsavers.trailing-edge.com/pdf/dec/pdp11/xxdp/diag_listings/1140_45/028_MAINDEC-11-DCQKC-D_D_1140_1145_INSTRUCTION_EXERCISER_Sep74.pdf > > CQKC Test > > Pages 18 - 61 and beyond provide switch registers and code to follow. > > b > -- @ BillDeg: Web: vintagecomputer.net Twitter: @billdeg <https://twitter.com/billdeg> Youtube: @billdeg <https://www.youtube.com/user/billdeg> Unauthorized Bio <http://www.vintagecomputer.net/readme.cfm>
