onsdag 20 september 2017 skrev Rod Smallwood via cctalk < [email protected] <javascript:_e(%7B%7D,'cvml','[email protected]');>>:
> > I installed the RX01 Unibus adapter in slot 5 > > Then replaced the slot 5 NPG jumper (RX01 is not DMA) They are underneath > the motherboard on an 11/94 > > Next I connected up the RX01 and used original DEC RT-11 v5.4 RX01 > distribution disks. > > Then turned on and tried to boot DX. > > Same result it says Trying. Some things to check unless you already done so: The RX11 (M7846) and RX211 (M8256) are known working? Are they correctly configured in regards to address and vector? Is it possible to access the CSR of the boards through the ODT prompt? Is it possible to do simple commands through the CSR port using ODT? After it hangs in the boot can you get into ODT mode and check if the bootstrap has read in the bootblock to address 0 and onwards ( or whatever the ROM boot code reads the bootblock to). /Mattis > If you have an 11/84 then whats on the KDJ-11 dialog screen would be very > interesting. > Which KDJ-11 do you have? > > Can you get a picture of your console screen set up to boot from an RX01 > or RX01? > > Rod > > > On 20/09/2017 13:47, Ulrich Tagge via cctalk wrote: > >> Hi Rod, > > I had an similar issue, when trying to boot a RX02 Disk >> created on >> > my > /84 on a /34a. Have bypassed this and have installed a fresh RT11, > > but had no time to figure out the problem. Would it of interest for > you, > to get RX02 Images (PDP11GUI) of my RT-11 V5.4 G Distribution > Set? With > them, you could install your /94 from scratch, ... . > > Many Greetings > > > Ulrich > > -- > Wanted one pdp-8/i rocker switch leaver to copy. > > 02 >
