Noel said > I just had a look at my -11/20 (the two are basically the same machine; the > /15 was intended for the OEM market, the /20 the end-user), and it has an > intermediate between this, and the final incandescent bulb form (as on the > -11/45), where there were bulbs with plastic bases plugged into sockets. > > The -11/20 has the same bulbs, but apparently soldered directly into the > panel; I looked at the prints (it's in the 'KY11-A Programmer's Console' > stuff - I see Manx says the prints aren't online, I'll have to scan my set), > and there are bulbs in the parts list, but no sockets.
The 11/15 I have appears to be a KC11 with KY-11C console board. I have the complete print set for this 11/15, a while ago I was asked for a partial scan of the KY-11C pages by another 11/15 owner as it differed sufficiently from the 11/20 print set and apparently the scan was just what was needed. I don't know if that person is on cctalk though, if so please pipe up. Since I have not found this anywhere (please correct me accordingly) I hope to get to scan the 11/15 print set, on my little A4 scanner it's going to take rather a lot of time. Steve.
