On 2/6/19 6:33 PM, Brent Hilpert via cctalk wrote: > Granted you could drill the holes from the rear of the flange, > however from what I can see the hinge design doesn't look like it > will allow the transport frame to swing far enough to clear access > for the screwdriver shaft to tighten the screws from the front (might > swing to around 110deg, but not to 170-180). The 2-1/2" thick > transport frame pivots near the middle of it's thickness, at 90deg > half the thickness is still well across the flange. You'd need a ~ < > 1" clearance right angle screwdriver to fit between the flange and > the transport frame, or bolt head screws and box wrench which then > necessitates the milling of clearance for the heads out of the cast > frame.
Nah, there's plenty of room to get a screwdriver in there. I've had much tighter spots. --Chuck
