I have RA60 prints, with notes, RA81 Maint Guide AA-M879B-TC RA80 MG AA-M186B-TC RM80 POCKET SERV GUIDE EK-0RM80-PG-001 RA81 Field Maint print set MP-01359?
I also have prints and or manuals for RP04/5/6 RK611, RK06/07 TUxx and parts for mass bus devices which I will never use. I have no problem selling heads and other parts, but not sure on documentation yet. If i do sell them, the buyer must agree to scan and send copies to Al. I still want to sell off all my q-bus- about 10-15 boxes, and maybe 600 or more boards. All Vax is going. I also have several 8-E boxes, and some boards. also 100 or so non- DEC boards such as Able, CMD, Dilog, Emulex, ETC. Paul On Mon, Oct 21, 2019 at 12:41 AM Paul Anderson <used...@gmail.com> wrote: > I pulled some RA60, R80, R81, etc. prints and manuals earlier, but left > them in the basement when I came upstairs.I will bring them up tomorrow > and put out a list. > > Thanks, Paul > > On Sun, Oct 20, 2019 at 5:47 PM Josh Dersch via cctalk < > cctalk@classiccmp.org> wrote: > >> On Fri, Oct 18, 2019 at 1:45 PM Antonio Carlini via cctalk < >> cctalk@classiccmp.org> wrote: >> >> > On 18/10/2019 05:51, Josh Dersch via cctalk wrote: >> > > >> > > (I should also note that there is an R80 service manual on Bitsavers >> -- I >> > > misspoke (mistyped?) in my initial e-mail. It doesn't provide a lot >> of >> > > details on the drive's operation and I was hoping the RA80 or RM80 >> > manuals >> > > might be more detailed...) >> > >> > I'm guessing you mean AA-M186B-TC "RA80 Maintenance Guide", but if not, >> > that's there. >> > >> > (Assuming I've not mis-typed something, I seem to have a later version, >> > AA-M186C-TC, but I've not scanned that). >> > >> > >> > Someone else was looking 10 years ago: >> > >> > >> > >> > >> https://alt.sys.pdp11.narkive.com/gXk9CvKT/looking-for-ra80-service-manual-ek-ora80-sv >> >> >> Yeah, I saw that while searching as well. The service documentation >> that's >> available for the R80/RA80 is somewhat useful but lacks detailed technical >> information, it's a step above a board-swapping guide for service techs, >> basically. >> >> I spent some time yesterday with the schematics (which, annoyingly, don't >> match my revision of the boards...) and immediately discovered that the >> optical sensor on the spindle wasn't working anymore -- it was definitely >> operational when I first started working on it but apparently it gave up >> the ghost after running for a few hours. So at minimum I need to fix >> that, >> there may still be other faults. The sensor picks up light, but it looks >> like the LED light source on the other end of it is dead. I'm going to >> attempt to bodge in a replacement IR LED and see if that's good enough... >> >> Thanks all, >> Josh >> >> >> >> > >> > >> > >> > but seemingly with no luck. >> > >> > >> > I think the FMPS must be on bitsavers but I hit this first: >> > >> > >> > https://usermanual.wiki/Document/MP01286RA80Mar82.3622064137 >> >> >> >> >> >> > >> > >> > >> > Antonio >> > >> > >> > -- >> > Antonio Carlini >> > anto...@acarlini.com >> > >> > >> >