Ok, so to get back to technology I have been working on fixing the
TK50's I have here along with attempting to look at some old tapes from
Bob's basement. It's been interesting.
So far one of the units works well with one of my tapes (stored indoors
for about 20 or so years) after a good cleaning with 95% isopropyl
alcohol. From RT11 I was able to initialize the tape, write 40mb of .DSK
image files, and consistently read the files back (to a VM: memory
drive) and diff/bin them to make sure they are the same. Good.
First test: A second TK50 drive I had banging around. This one will read
the tape, but fail about half way through. May still be a bit dirty,
will clean and check.
Second test: Checking some of the tapes from Bob's basement. In addition
to getting the PERQ tapes out of there I had a few TK50 tapes mixed in,
most with degaussed stickers on them from long ago. These tapes appear
to have been Vax 8650 load tapes of some sort, no idea if there is any
value to the data but one was labelled Micro-pdp11 diagnostics and since
I know those are backed up I started with that one.
It loads, but fails with a DUP IO output error. It also messes up the
tape head so I have to clean it after testing. Most of the dirt is at
the bottom of the head. After cleaning the drive can load and read the
"control" tape which has all of those image files on it, so it doesn't
damage the drive. Still I see why taking the cage top off the TK50 is a
good idea. :-)
Took the cartridge apart and here is what I see:
https://i.imgur.com/xHhiBAW.jpg
This is... not good. Dirt or something on the bottom of the tape. Now
these did spend the last 20 years in a pretty dank basement with an oil
fired house heater so there is probably that. Still I used a Q tip on
the tape with isopropyl alcohol and it came up dirty inside the cart and
out:
https://i.imgur.com/TB91gGx.jpg
Also odd that the tape is wrapped in two different "levels" on the
spindle. Maybe that's normal. So a question:
Can one clean tape with isopropyl alcohol? In theory if I could get the
controller to slowly run the tape onto the take-up real to the EOT
marker I could soak some cotton swabs and use them to clean the tape
before it hits the heads (to minimize head wear). Or I could just chuck
these tapes and see how a couple I am buying from Ebay hold up.
This is mostly an academic exercise: It gives me something to do. But I
am wondering if the tapes were crudded by the environment or if this is
just natural tape degradation. I do have one final tape that was in a
closed tape holder so it might be better (it's clean on the outside).
Will see....
C
