On 08/10/2020 04:31 PM, William Sudbrink via cctalk wrote:
Hi All,
I'm going to be attempting to repair, both cosmetically and operationally, a
circuit board that had a strip of 12 volt trace "blown off" of it by a
short. The fiberglass is clean and there was no solder resist in the
affected area. I'm considering using 3M 1183 adhesive tinned foil tape for
the job. Has anyone else done this? Could you recommend this or another
product? Any tips?
I usually repair these with solid copper wire, but then I'm
not trying to make it cosmetic, too.
Jon
